1、將重慶升降平臺待安支架運至規定的地點，按操作規程要求將車盤停穩、支牢后，分別卸掉支架車固定的連接裝置，前面用卸車的絞車曰繩拉向支架底座前方，待所有人員撤離到安全地點后，開動絞車，將支架沿卸車斜臺拖下車盤。
Wenzhou lifting platform will be transported to the required safety stand location, follow the rules and parked the car plate, posterior branch in prison, respectively, remove the bracket car fixed connection device, said front winch with unloading hove to stand in front of the base, after all personnel to evacuate to a safe place after starting the winch, the bracket along the unloading ramp dragged off the disk.
   
2、利用工作面安設的回柱絞車，拖拉住溫州升降平臺支架不同部位進行前移、調向，最后將支架拖正就位，拆掉支架與絞車的繩栓。對各部銷子、螺栓進行檢查、緊固，清理工具，縮回絞車鋼絲繩。
Use Face install the winch, lifting platform bracket drag Wenzhou live in different parts of forward, adjust to, and finally stand being dragged into place, and remove the bracket and bolt rope winch. For ministries pins, bolts checked, tightening, cleaning tool, retract winch rope.
   
3、接通升降平臺支架進、出液管路，檢查無誤后即可送液，將支架前、后立柱升起，并及時調整立柱加長段，待升平前梁后，伸出防片幫板，支架達初撐力后，將手柄恢復零位，最后將框架推出，用連接耳與液壓升降機刮板輸送機相連。
Wenzhou lifting platform bracket turned into and out of fluid piping, check and correct solution to feeding the front bracket, rear pillar rises, and adjust the column lengthened segment, to be Shengping front beam, extending anti-spalling board, stand up setting load, it will handle the recovery zero, and finally the framework introduced by connecting the ear and connected to a hydraulic elevator scraper conveyor.